Servo Motor Drivers

The NX Series servo motor drivers allow for easy operation and control of the servo motors. 4 Control Modes are available: Position, Speed, Torque and Tension Control. The driver provides automatic tuning allowing for optimal performance without manual adjustments.

• Built-in Protective Functions
• Pulse Input Type
• Single-Phase 100-115 VAC, Single-Phase 200-230 VAC, Three-Phase 200-230 VAC
• Works with NX Series Tuning Free Servo Motors*

These products use our AlphaStep closed loop technology to maintain positioning operation even during abrupt load fluctuations and accelerations without hunting or gain tuning. The rotor position detection sensor monitors the rotation speed and amount. When an overload condition is detected, it will instantaneously regain control using the closed loop mode. When an overload condition continues it will output an alarm signal, thereby providing reliability.

Using energy saving technology provides lower motor heat output with up to 47% less power consumed. Advanced driver technology provides low vibration along with multiple driver types depending on your system configuration. Use the MEXE02 data setting software for easy set up and monitoring.

• Absolute Mechanical Encoder or Resolver Types
• Pulse Input, Pulse Input with RS-485 Communications, Stored Data (Network), EtherNet/IP™ or EtherCAT Compatible Types 
• For use with AZ Series or AR Series Motors